Programming a rolling code – Dodge 2012 Challenger-SRT - Owner Manual User Manual

Page 158

Advertising
background image

Programming A Rolling Code
For programming garage door openers that were manu-

factured after 1995. These garage door openers can be

identified by the “LEARN” or “TRAIN” button located

where the hanging antenna is attached to the garage door

opener. It is NOT the button that is normally used to

open and close the door. The name and color of the

button may vary by manufacturer.

1. Turn the ignition switch to the ON/RUN position.
2. Place the hand-held transmitter 1 to 3 inches (3 to 8 cm)

away from the HomeLink௡ button you wish to program.

Training The Garage Door Opener

1 — Door Opener

2 — Training Button

156 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Advertising