Enabling and disabling parksenseĥ, Service the parksenseĥ rear park assist system, Enabling and disabling parksense – Dodge 2013 Dart - Owner Manual User Manual

Page 242: Service the parksense௡ rear park assist, System

Advertising
background image

Enabling And Disabling ParkSense

ParkSense

௡ can be enabled and disabled using the

Uconnect

௡ System. The available choices are: Off, Sound

Only, or Sound and Display. Refer to “Uconnect

௡ Set-

tings” in “Understanding Your Instrument Panel” for
further information.

When the ParkSense

௡ soft-key is pressed to disable the

system, the EVIC will display the “PARK ASSIST SYS-
TEM OFF” message for approximately five seconds.
Refer to “Electronic Vehicle Information Center (EVIC)”
in “Understanding Your Instrument Panel” for further
information. When the shift lever is moved to REVERSE
and the system is disabled, the EVIC will display the
“PARK ASSIST SYSTEM OFF” message for approxi-
mately five seconds.

Service The ParkSense

Rear Park Assist System

When the ParkSense

௡ Rear Park Assist system is mal-

functioning, the Electronic Vehicle Information Center
(EVIC) will actuate a single chime, once per ignition
cycle, and it will display the “WIPE OFF REAR PARK
ASSIST SENSORS”, “SERVICE PARK ASSIST SENSORS”
or “SERVICE PARK ASSIST SYSTEM” message. Refer to
“Electronic Vehicle Information Center (EVIC)” in “Un-
derstanding Your Instrument Panel” for further informa-
tion. When the shift lever is moved to REVERSE and the
system has detected a fault condition, the EVIC will
display the “WIPE OFF REAR PARK ASSIST SENSORS”,
“SERVICE PARK ASSIST SENSORS” or the “SERVICE
PARK ASSIST SYSTEM” message for as long as the
vehicle is in REVERSE. Under this condition, ParkSense

will not operate.

240

UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Advertising