To enter the vehicle after remote start, To exit remote start mode and drive the vehicle – Dodge 2013 Grand_Caravan - Owner Manual User Manual

Page 35

Advertising
background image

• For security, power window and power sunroof op-

eration (if equipped) are disabled when the vehicle is
in the Remote Start mode.

• The engine can be started two consecutive 15-minute

cycles with the RKE transmitter. However, the ignition
switch must be turned to the ON/RUN position.

To Enter the Vehicle After Remote Start

To enter the vehicle while the engine is running during a
Remote Start, you must first unlock the vehicle using the
UNLOCK button on the transmitter. After the vehicle is
unlocked, you can enter the vehicle, insert the Key Fob
into the ignition switch and turn it to the ON/RUN
position, otherwise the engine will shut off at the end of
15-minute cycle.

To Exit Remote Start Mode And Drive The Vehicle

Before the end of the 15-minute cycle, press and release the
UNLOCK button on the RKE transmitter to unlock the
doors and disarm the Vehicle Security Alarm (if equipped).
Then, prior to the end of the 15-minute cycle, insert the Key
Fob into the ignition switch and turn the switch to the
ON/RUN position.

NOTE:

• The ignition switch must be in the ON/RUN position

in order to drive the vehicle.

• The message “Remote Start Active — Key To Run” will

display in the EVIC until you insert and turn the key to
ON/RUN position. Refer to “Electronic Vehicle Infor-
mation Center (EVIC)” for further information.

2

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

33

Advertising