Securing the spare tire, Road tire installation, What to do in emergencies – Dodge 2013 Grand_Caravan - User Guide User Manual

Page 94

Advertising
background image

Securing The Spare Tire

1. Assemble the winch handle extensions to form a T-handle and fit the winch T-handle over

the drive nut. Rotate the nut to the left until the winch mechanism stops turning freely.
This will allow enough slack in the cable to allow you to pull the wheel spacer out from
under the vehicle.

2. Assemble the winch handle extensions to form the spare tire hook, and pull the wheel

spacer from under the vehicle.

3. Turn the compact spare tire so that the valve stem is down, and place the tire into the

spare tire/cover assembly. Slide the wheel spacer through the center of the wheel and
spare tire/cover assembly, so that the two retainer tabs snap out and engage the spare
tire cover on the opposite side.

4. Using the winch T-handle, rotate the drive nut to the right until the compact spare

tire/cover assembly is drawn into place against the underside of the vehicle.

5. Continue to rotate the nut to the right until you hear the winch mechanism click three

times. It cannot be overtightened. Check under the vehicle to ensure the compact spare
tire/cover assembly is positioned correctly against the underside of the vehicle.

Road Tire Installation

Vehicles Equipped With Wheel Covers

1. Mount the road tire on the axle.

2. To ease the installation process for steel wheels with wheel covers, install two lug nuts

on the mounting studs which are on each side of the valve stem. Install the lug nuts with
the cone shaped end of the nut toward the wheel. Lightly tighten the lug nuts.

3. Align the valve notch in the wheel cover

with the valve stem on the wheel. Install
the cover by hand, snapping the cover
over the two lug nuts. Do not use a ham-
mer or excessive force to install the
cover.

4. Install the remaining lug nuts with the

cone shaped end of the nut toward the
wheel. Lightly tighten the lug nuts.

5. Lower the vehicle to the ground by turn-

ing the jack handle counterclockwise.

1 — Valve Stem

4 — Wheel Cover

2 — Valve Notch

5 — Mounting Stud

3 — Wheel Lug Nut

WHAT TO DO IN EMERGENCIES

92

Advertising