To enter the trunk, Engine starting/stopping, Getting started – Dodge 2014 Charger-SRT - User Guide User Manual

Page 14

Advertising
background image

To Enter the Trunk

• With a valid Keyless Enter-N-Go™ Key Fob

located outside the vehicle and within 5 ft
(1.5 m) of the deck lid, press the button on
the right side of Center High Mounted
Stop Light (CHMSL) which is located on
the deck lid.

• Whenever the vehicle is unlocked, you

can enter the trunk by pressing the button
on the right side of the CHMSl.

NOTE:
Refer to your Owner's Manual on the DVD for
further information.

Engine Starting/Stopping

Starting

• With a valid Keyless Enter-N-Go™ Key Fob

inside the vehicle.

• Shift the transmission into PARK or NEU-

TRAL.

• While pressing the brake pedal, press the

ENGINE START/STOP button once. If the
engine fails to start, the starter will disen-
gage automatically after 10 seconds.

• To stop the cranking of the engine prior to

the engine starting, press the button again.

NOTE:
In case the ignition switch does not change
with the push of a button, the RKE transmit-
ter (Key Fob) may have a low or dead battery.
In this situation a back up method can be
used to operate the ignition switch. Put the nose side of the Key Fob (side opposite of the
Emergency Key) against the ENGINE START/STOP button and push to operate the ignition
switch.

1 — Trunk Button

1 — Engine Start/Stop Button

GETTING STARTED

12

Advertising