Electronic throttle control (etc) indicator light, Air bag warning light, Service awd system message – Dodge 2014 Charger-SRT - User Guide User Manual

Page 82: Sport shifting, Sport suspension indicator, Oil change indicator, What to do in emergencies

Advertising
background image

- Electronic Throttle Control (ETC) Indicator Light

• This light informs you of a problem with the system.

• If a problem is detected, the light will come on while the engine is running. Cycle the

ignition when the vehicle has completely stopped and the shift lever is placed in the
PARK position; the light should turn off.

• If the light remains lit with the engine running, your vehicle will usually be drivable;

however, see an authorized dealer immediately. If the light is flashing when the engine is
running, immediate service is required and you may experience reduced performance,
an elevated/rough idle or engine stall and your vehicle may require towing.

- Air Bag Warning Light

• If the light is not on during starting, stays on, or turns on while driving, have the vehicle

serviced by an authorized dealer immediately.

SERVICE AWD SYSTEM Message

• If the SERVICE AWD SYSTEM warning message appears after engine start up, or during

driving, it means the AWD system is not functioning properly. We recommend you do not
operate the vehicle. Have the vehicle serviced immediately.

– Sport Shifting

• This light will illuminate when SPORT mode is selected. This mode provides performance

based transmission shifting depending on the driver requested throttle position.

Sport Suspension Indicator

• The light will illuminate when Sport or Track mode is selected. This mode provides

performance based tuning with improved handling through an electronic controlled
damping system.

Oil Change Indicator

Message

• If an “oil change due” message (shown as Oil Change Due) appears and a single chime

sounds, it is time for your next required oil change.

Resetting The Light After Servicing

Vehicles Equipped With Keyless Enter-N-Go™

• Without pressing the brake pedal, push the ENGINE START/STOP button and cycle the

ignition to the ON/RUN position (Do not start the engine.)

• Fully depress the accelerator pedal, slowly, three times within 10 seconds.

• Without pressing the brake pedal, push the ENGINE START/STOP button once to return

the ignition to the OFF/LOCK position.

WHAT TO DO IN EMERGENCIES

80

Advertising