Vertical Communications DSU and DSU II - Manual (Page 99)

9.2 LCD Messaging
You can set system-supplied messages to be received or displayed by a
calling LCD speakerphone. These messages give information on your
telephone status. Get a list of the available messages from the attendant
and write them on the blank listing chart on the next page.
•
To turn message on,
1. Press INTERCOM.
2. Dial ✳ 0 2.
3. Dial the desired number from your message list. The default
messages of “Back At” and “Call” may be used:
For default message 1, which is “Back At,” dial time in
twelve-hour format using the # as a colon.
For default message 2, which is “Call,” dial the telephone number
of where you will be.
4. Press SPEAKER to end message. Intercom light flashes steadily.
•
To turn off message and your intercom light,
1. Press INTERCOM.
2. Dial # 0 2.
LCD Message List
(Write Attendant-provided messages here)
0
1 Back At
2 Call
3
4
5
6
7
8
9
GCA70–245 Using Non-Verbal Messaging
LCD Speakerphone Reference Manual 9–3