Chief Manufacturing Large Flat Panel Dual Arm Wall Mount PNR - Manual (Page 9)

Installation Instructions Model PNR™
9
Figure 12
Swing Arm Adjustments
The dual swing arms are shipped installed in the center
of the top and bottom mounting brackets, which is the
standard mounting configuration.
The top and bottom mounting brackets have slotted
holes, allowing for lateral adjustment of the dual swing
arms.
After the top and bottom mounting brackets have been
installed between two wood studs 16” on center, the
swing arms can be adjusted or moved off center,
depending on the location of the mount, the size of the
display, and the lateral movement needed to rotate the
display.
The swing arms can be adjusted, as follows:
• Adjusting the Swing Arms Off-Center
With no disassembly required, you can adjust the swing
arms up to 1-inch to the left of center or up to 1-inch to
the right of center.
• Reconfiguring the Swing Arms Left of Center
With some disassembly and reassembly required, you
can move the swing arms to the left of center by
reconfiguring the mount. Use the first and third slotted
holes in the top and bottom mounting brackets.
• Reconfiguring the Swing Arms Right of Center
With some disassembly and reassembly, you can move
the swing arms to the right of center by reconfiguring the
mount. Use the third and fifth slotted holes in the top and
bottom mounting brackets.
Adjusting the Swing Arms Off Center
To adjust the dual swing arm mount configuration:
1. Remove the display from the mount.
2. Loosen four bolts (two on the top and two on the
bottom) securing the swing arm assembly to the top
and bottom mounting brackets (See figure 13).
3. Move the swing arm assembly to desired location.
4. Tighten the bolts.
5. Install the display on the mount.
Figure 13
Reconfiguring the Swing Arms to the Left or
Right of Center
To change of the dual swing arm mount configuration:
1. Remove the display from the mount.
2. Remove four bolts (two on the top and two on the
bottom) securing the swing arm assembly to the top
and bottom mounting brackets (See figure 14).
WARNING: The next step will release the arm
assembly from the mount. The arms and plate may fall
if you are not careful.
3. Move the swing arm assembly to desired location.
• For Left of Center, see Figure 14.
• For Right of Center, see Figure 15.
4. Install retaining pin assemblies (one top and one
Rotational Tilt
Adjustment Nut
Lateral Tilt
Adjustment Nut
Top Bolts