Canon REALiS X700 - Manual (Page 25)

25
BE
FORE USE
(1) Input Terminal-1 (DIGITAL IN/ANALOG IN-1) (P34, 35, 63)
Receives a digital (DIGITAL PC) and analog PC signal (ANALOG PC-1).
Receives a digital content image signal (DIGITAL VIDEO).
(2) Input Terminal-2 (ANALOG IN-2) (P34, 35, 62)
Receives an analog PC signal (ANALOG PC-2).
Receives a component and SCART image signal (COMPONENT/SCART).
(3) Monitor Output Terminal ( ) (P36)
Outputs an analog PC signal to display an image on an external monitor.
(4) AUDIO OUT terminal (SX7/X700) (P66)
The audio output terminal to output an audio to an external audio device.
It outputs the audio signal corresponding to the projected image signal.
(5) AUDIO IN terminal (P36, 37)
SX7/X700: The audio input terminals corresponding to 3 image input systems.
Each terminal receives the audio signal corresponding to "DIGITAL
PC/ANALOG PC-1", "ANALOG PC-2", and "S-VIDEO or VIDEO" from
the left.
The internal speaker outputs the audio signal corresponding to the
selected image signal.
SX6/SX60: The input terminal of an audio signal.
The internal speaker outputs the audio signal no matter what the
image signal is inputted.
(6) VIDEO IN terminal (P64)
Receives a composite video signal from an AV equipment.
(7) S-VIDEO IN terminal (P64)
Receives an S-Video signal from an AV equipment.
(8) SERVICE PORT jack
Exclusively used by the service personnel (it is not used normally).
(9) USB terminal (P80)
Connected to the computer with a USB cable when the remote control is used
as the mouse of the computer. (you cannot use this terminal to receive any
video image)
(10) Input Terminal Indicator (P46, 68)
Indicates the input signal status.
Green
: The input signal is confirmed and an image is projected.
Flashing green : The input signal is confirmed but no image is projected.
Off
: An input signal is not confirmed (a cable is not connected).