Cobra Electronics XRS 9965/70G - Manual (Page 10)

English 14
EasySet Menu
Your Detector
Intro Operation Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
Nothing Comes Close to a Cobra ® 15
EasySet Menu
Your Detector
Intro Operation Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
To use EasySet Menu:
1. Click on the Menu icon on the touchscreen
to reach the opening menu screen.
2. Choose whether you want to change:
a. User Settings – click on the User icon.
(see page 19)
b. Alert Settings – click on the Alert icon.
(see page 25)
c. GPS Settings – click on the GPS icon.
(see page 38)
EasySet Menu
•
EasySet Menu gives you quick and easy access to all the settings on your detector.
It is used to select:
n
User Settings (see page 19)
n
Alert Settings (see page 24)
n
GPS settings only if the GPS Locator is installed (see page 38)
Refer also to the Menu Flow Diagrams on pages 16, 17 and 18 for User Settings,
Alert Settings, and GPS Settings to easily navigate to the setting you want to change.
All settings are stored in memory when the power is turned Off and
will be recalled when the power is turned back On. There are also shortcuts to some
frequently accessed settings. The shortcuts are described in the sections relating to
those settings.
NOTE
You cannot enter
Menu mode during an alert. The unit will not detect
signals while in Menu mode.
During menu setting, if no icons are clicked or pressed for 15 seconds,
the unit will automatically exit Menu mode and save the most recent settings.
If power is turned Off while in Menu mode, settings are saved to those
in effect before Menu mode was entered.
3. Click the 3 or 4 navigation arrows at the bottom of
the touchscreen to step backward or forward through
the chosen settings loop until the desired setting
is reached.
4. Click on the check box icon to toggle the setting On and Off.
Some settings will have multiple choices rather than On
and Off; in those cases, click on the choice you want. Other
settings will display minus (-) and plus (+) icons to allow
you to step through a series of options for the setting. A
few settings involve a series of steps which are explained
on those screens.
5. Repeat steps 3 and 4 to move to and set the next desired
setting(s). Continue to use the 3 and 4 navigation arrows to
set the other options.
6. Click the Exit icon at the bottom center of the display when
finished.
This will save your settings, exit the EasySet Menu mode,
and return the unit to the Main Standby screen.
NOTE
If no icons are clicked or pressed for ten seconds while in the
select menu screen, the unit will return to the Main Standby screen.
If no icons are clicked or pressed for fifteen seconds while in any
sub-menu screen, the unit will return to the Main Standby screen.