FRIGIDAIRE FAFI15D7MN - Manual (Page 6)

6
Filling the Water Reservoir
1 always ensure that the iron is unplugged from the wall outlet
prior to filling the water reservoir.
2 if filling a hot iron, exercise extreme caution.
3 set the steam selector to the off position, open the cover of
the Water fill hole and place the iron in a vertical position.
4 pour water into the Water fill hole, making sure that the
water level does not exceed the Maximum fill line.
Ironing
1 for both dry and steam ironing, set the steam selector to
the off position. if you will be steam ironing, follow the
“filling the Water Reservoir” steps.
2 insert the power cord plug into a 120-Volt ac outlet.
3 press the fabric selector buttons to illuminate the type of
fabric that will be ironed and then place the iron on the heel
rest to allow it to heat up.
4 While the iron is heating up, the Wait indicator will be
illuminated. once the iron is heated for the selected fabric,
the Ready indicator will illuminate. the iron is now ready for
use.
5 if steam ironing, set the steam selector to the desired level
of steam output.
Turning Off and Storing the Iron
1 press the (-) fabric selector button until the lights turn off.
2 set the steam selector to the off position.
3 unplug from the outlet by grasping the plug and pulling.
never yank the power cord to unplug the iron as this may
damage the plug and cable.
4 if the iron will not be used the following day, empty the
water reservoir. ensure the iron is unplugged and turn
upside down over a sink. open the cover of the Water fill
hole and empty the water into the sink, gently shaking out
any water drops.
5 allow the iron to cool completely. loosely circle the cord
around the heel rest and store the iron resting on the heel
rest. do not wrap the cord too tight as this could damage
the cord.
USING YOUR IRON