Casio TC-520 - Manual (Page 27)

14 14 14 14 14
PAGE
PAGING THE HANDSET
FROM THE
BASE UNIT
LOW BATTERY
INDICATOR
HANDSET
HANDSET MESSAGE
WAITING INDICATOR
In the "Standby Mode," if you have messages,
the
MESSAGE INDICATOR flashes for 7
seconds after the handset is used. (In the
"Standby Mode" the
TALK INDICATOR is
not lit.)
LO BATT
When the battery pack needs
recharging, the
LO BATT
INDICATOR (Low Battery)
on the handset will flash. You
may also notice a reduction in
the quality of your cordless handset
communications. Return the cordless handset to
the base unit when the
LO BATT
INDICATOR is flashing.
NOTE: The batteries can be recharged many times, but if you
get a low battery indication even after 12-15 hours of charging,
you should replace the battery pack.
BATTERIES
- The TC-520 is shipped
with the handset battery pack installed. If it
becomes necessary to remove or replace the
batteries see page 32.
To page the handset from
the base unit, the handset
must be in the “Standby”
mode (the
TALK
INDICATOR is not lit.)
1 Press PAGE on the base unit. You will
hear the handset ring, if the ringer switch
is set to ON.
PAGING, BATTERY & PLA
MESSAGE
TALK
PAGE
CHARGING
LINE IN USE
2 Place the handset in the base unit. The
CHARGING/LINE IN-USE
INDICATOR
on the base unit lights to
indicate the TC-520 is charging.
1 Check the AC Adapter to see that it is
connected correctly.
Charge the batteries for 12-15 hours before
using the cordless handset for the first time. The
handset is always charging while it is in the base
unit and cannot be overcharged.
CHARGING THE
BATTERIES
PAGE
2
To cancel the page press PAGE .