Acronis Access Advanced - Installation Guide - Manual (Page 156)

156 Copyright © Acronis International GmbH, 2002-2014
6 Quick Start: Mobile Access
This guide provides the essential steps for setting up a Gateway Server, adding a Data Source and
installing the Access Mobile Client app. For more detailed instructions on configuring the Acronis
Access Gateway Server and the Client Management components, see the Managing Gateway Servers
and Mobile Access sections.
In this section
First Run ................................................................................................. 156
Configuring Your First Gateway Server and Data Source ...................... 159
Setting up a Policy .................................................................................. 162
Installing the Access Mobile Client application ..................................... 163
Enrolling in client management ............................................................. 164
6.1 First Run
If you haven't done so already, install and configure Acronis Access. For more information on doing
so, check the Installing (p. 5) and Configuration Utility (p. 9) sections.
When you first open the web interface, you will have to set a password for the default administrator
account and after you log in, you will be greeted by the Setup Wizard.
Warning! Please do not forget your administrator password as the support department cannot recover this
password for you
Note: It may take 30-45 seconds until the application becomes available after starting it from the Configuration
Utility.
Once you have completed the above, you are ready to go through the Initial Configuration described
below.
General Settings
1. Enter a Server Name.