FRIGIDAIRE FGEF308TNF - Manual (Page 17)

17
SETTING OVEN CONTROLS
 NOTE
The surface elements cannot be activated when the
Lockout feature is active (see the section: The electronic
surface element control (ESEC)).
SETTING LOCKOUT FEATURE
The pad controls the Lockout feature. The Lockout
feature automatically locks the oven doors, the control
panel and the cooktop. It does not disable the Minute
Timer or the interior oven lights.
To activate the Lockout feature
1. Press and hold
for 3 seconds.
2. After 3 seconds "Loc" and "Control" will appear, a beep
will sound, "UPPER", "LOWER" and "DOOR" will fl ash
in the display. Once the oven door is locked the "DOOR"
will stop fl ashing and remain on along with the "Loc",
"Control" and the icon will appear.
To reactivate normal operation:
1. Press and hold for 3 seconds. A beep will sound.
The "UPPER", "LOWER" and "DOOR" will fl ash in the
display until the oven door has completely unlocked
and the icon will disappear.
2. The unit is again fully operational.
SETTING MINUTE TIMER
The TIMER ON.OFF pad controls the Minute Timer
feature. The Minute Timer serves as an extra timer in
the kitchen that will beep when the set time has run
out. It does not start or stop cooking. The Minute Timer
feature can be used during any of the other oven control
functions. Refer to “Minimum and Maximum Control Pad
Settings” for time amount settings.
To set the Minute Timer (example for 5 minutes)
1. Press TIMER ON.OFF. "-- --" will appear in the
display.
2. Use the number pads to set the desired time in the
display; press 5.
3. Press START. The time will begin to count down with
"5:00" in the display.
Note: If START is not pressed the timer will return to the
time of day after 25 seconds.
4. When the set time has run out, "End" will show in
the display. The clock will sound with 3 beeps every 5
seconds until TIMER ON.OFF is pressed.
To cancel the Minute Timer before the set time has
run out
1. Press TIMER ON.OFF. The display will return to the
time of day.
SETTING ADD 1 MINUTE FEATURE
The ADD 1 MINUTE pad is used to set the Add 1 Minute
feature. When the ADD 1 MINUTE pad is pressed,
1 minute is added to the Minute Timer feature if this
feature is already active. If the Minute Timer feature is
not active and the ADD 1 MINUTE pad is pressed, the
Minute Timer feature will become active and will begin
counting down from 1 minute.
SETTING SILENT CONTROL OPERATION
The DELAY START and SELF CLEAN pads control
the Silent Control operation feature. The Silent Control
operation feature allows the oven control to be operated
without sounds or beeps whenever necessary. If desired
the control can be programmed for silent operation and
later returned to operating with all the normal sounds
and beeps.
To change control from normal sound operation to
silent control operation
1. To tell if your range is set for normal or silent
operation press and hold DELAY START. "-- --" will
appear and "DELAY" will fl ash in the display. After 6
seconds "bEEP On" or "bEEP OFF" will appear in the
display.
2. Press SELF CLEAN to switch between normal sound
operation and silent operation mode. The display will
show either "bEEP On" or "bEEP OFF".
Note: If "bEEP On" appears, the control will operate with
normal sounds and beeps. If "bEEP OFF" appears, the
control is in the silent operation mode.
3. Press START to accept the change or press CLEAR
to reject the change.
Note: The control will always beep at the end of a minute
timer and will beep when a set temperature has been
reached, even if the control is set to silent operation.