Dell PowerEdge 860 - Manual (Page 2)

Using the Setup Password
When a setup password is enabled for the System Setup program, the system gives you one chance to
enter the setup password correctly. If you enter the password incorrectly, the system displays an error
message and opens the System Setup program for viewing only. You will not be able to change any of
the System Setup fields except for the system password. If you have already entered the system password
during the current session, you can change the system password if the Password Status field is set to
Unlocked. To change the Password Status field from Locked to Unlocked, you must enter the correct
setup password.
__________________
Information in this document is subject to change without notice.
© 2006 Dell Inc. All rights reserved. Printed in Malaysia.
Reproduction in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden.
Trademarks used in this text: Dell and the DELL logo are trademarks of Dell Inc. Other trademarks and trade names may be used in
this document to refer to either the entities claiming the marks and names or their products. Dell Inc. disclaims any proprietary interest
in trademarks and trade names other than its own.
3 PWR_CONN Power supply connector
4 DIMM1_A Memory module
5 DIMM2_A Memory module
6 DIMM1_B Memory module
7 DIMM2_B Memory module
8 FAN Fan power connector
9 BATTERY 3.0 V coin battery connector
10 SATA_0 SATA 0 hard drive connector
11 SATA_1 SATA 1 hard drive connector
12 PCI_FAN PCI fan connector
13 FP_CONN1 Control panel interface connector
14 IDE Optical drive interface connector
15 HD_ACT_CARD Hard drive activity connector (expansion controller)
16 INTRUSION_SWITCH Connector for the chassis intrusion switch
17 RISER_CONN1 Riser card interface connector
Table 1. System Board Connectors (continued)
Item Connector Description