Cisco 2955 - Manual (Page 4)

4
Catalyst 2955 Switch DIN Rail Clip Installation Notes
OL-5262-01
Mounting the Switch on a DIN Rail
To attach the switch to a DIN rail, follow the procedures in this section.
Step 1 Position the rear panel of the switch directly in front of the DIN rail, making sure that the top of the DIN
rail clip hooks over the top of the DIN rail, as shown in
Figure 3 .
Figure 3 Mounting the Switch on a DIN Rail in a Parallel Configuration
1 DIN rail clip 3 DIN rail clip release tab
2 DIN rail
104562
1
2
3