Dell PowerVault 775N (Rackmount NAS Appliance) - Manual (Page 5)

I n f o r m a t i o n U p d a t e 1-1
This document provides updated information about the following topics for your system:
• Installing the SCSI cable strain-relief bracket
• System features
• Microprocessor features
• System memory features
• System board connectors for memory modules
• Broadcom NetXtreme Gigabit Ethernet Server Adapter
• Console redirection special key functions
Installing the SCSI Cable Strain-Relief Bracket
1 Turn off the system, including any attached peripherals, and disconnect the system
from the electrical outlet.
2 Ensure that the system is pushed back as far as possible in the rack.
3 Connect any SCSI cables to the system before connecting the I/O cables.
NOTE: To use the strain-relief bracket, only two SCSI cables can be connected to each I/O
slot at a time. The cables cannot be stacked, one above the other; they must be either side-
by-side or placed diagonally to each other.
4 Install the strain-relief bracket to the back of the system.
a Insert the ends of the three long portions of the strain-relief bracket into the three
matching holes in the rail bracket (see Figure 1-1).
b Secure the captive thumbscrew to the back of the system (see Figure 1-1).
5 Connect the I/O cables to the back of the system.
For information on routing system cables, see your Rack Installation Guide.