Dell PowerEdge R900 - Manual (Page 7)

Information Update
7
New SEL Sensor Messages
The following SEL sensor messages have been added to the systems
management software and remote access card software.
System Board Replacement - Safeguarding
Encrypted Data
On systems using an operating system that supports the Trusted Platform
Module (TPM) and related encryption programs, you can use these features
to secure the contents of the hard drive(s).
If you are using the TPM with an encryption program, you may be prompted
to create a recovery key during system or program setup. Be sure to create and
safely store this recovery key. If you ever need to replace the system board, you
must supply the recovery key when you restart your system or program, before
you can access the encrypted data on your hard drive(s).
Table 2. Sensor Message Definitions
Sensor Number Message Definition
0x26 PCIE Non Fatal
error
A non-fatal error occurred. The system
will continue to operate normally.
0x27 Generic Fatal
I/O Error
A fatal I/O error occurred. The system
will no longer respond.
0x28 Processor
Machine Check
Error
A processor error occurred. The system
will no longer respond.
NOTE:
For the full name of an abbreviation or acronym used in this table, see "Glossary"
in your Hardware Owner’s Manual.