Installing the versarails slide assemblies, Figure 1-5, Installing the rapidrails slide assemblies – Dell PowerEdge 1800 User Manual
Page 14
1-12
Rack Installation Guide
4
Repeat steps 1 through 3 for the slide assembly on the other side of the rack.
NOTE:
Ensure that the rails are mounted at the same vertical position on both sides of the rack.
Figure 1-5.
Installing the RapidRails Slide Assemblies
Installing the VersaRails Slide Assemblies
1
At the front of the rack cabinet, place a VersaRails slide assembly so that its mounting-bracket
flange fits between the marks or tape (or numbered location) on the rack (see Figure 1-6).
The holes on the front of the mounting bracket should align with the holes between the
marks on the front vertical rail.
2
Install two 10-32 x 0.5-inch flange-head Phillips screws in the mounting flange’s top hole and
the bottom hole (see Figure 1-6).
slide-assembly
mounting-bracket
flange
push button
front of rack
slide assemblies (2)
mounting hooks