Dell PowerEdge R905 - Manual (Page 12)

10
Information Update
Troubleshooting an SD+ Card or Internal USB Key
The following troubleshooting procedure is an update to the Hardware
Owner’s Manual. For information about the SD+ card and USB key ports
inside your system and installing or removing these types of memory devices,
see the installation procedures in your
Hardware Owner’s Manual.
Problem
• System cannot read data from an SD+ card or USB key.
Action
CAUTION:
Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
1 Enter the System Setup program and ensure that the SD+ card or USB
key port is enabled. See "Using the System Setup Program" in the
Hardware Owner’s Manual.
2 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
3 Open the system. See "Opening and Closing the System" in the Hardware
Owner’s Manual.
4 Reseat the SD+ card or USB key.
5 Close the system. See "Opening and Closing the System" in the Hardware
Owner’s Manual.
6 Reconnect the system to the electrical outlet, and turn on the system
and attached peripherals.
If the problem is not resolved, proceed to the next step.
7 Repeat step 2 and step 3.
8 Insert a different SD+ card or USB key that you know works properly.
9 Close the system. See "Opening and Closing the System" in the Hardware
Owner’s Manual.
10 Reconnect the system to the electrical outlet, and turn on the system
and attached peripherals.
If the problem is not resolved, see "Getting Help" in the Hardware Owner’s
Manual.