Dell PowerVault 132T LTO/SDLT (Tape Library) - Manual (Page 6)

4
Upgrading to LTO-3 Tape Drive Modules
www
.dell.com | support.dell.com
Figure 1-1. Removing the Drive Module Cover Plate
4 Carefully slide the new LTO-3 drive module into position. See Figure 1-2. The metal edge
on the drive module should be inserted into the plastic guide on the left side of the drive bay.
Figure 1-2. Inserting the Drive Module
5 Tighten the four thumbscrews on the drive module until it is flush with the chassis.
6 Recable the tape library.
• For SCSI, connect the drives to the host using SCSI cables and terminate the bus.
• For native FC, use an FC cable with an LC connector to attach the LTO-3 drive to an FC
host bus adapter or switch. Be sure that the connector on the other end of the FC cable
matches the device to which the LTO-3 drive is being attached.
7 Reconnect the tape library to an electrical outlet.