Chief Manufacturing CM8 - Manual (Page 2)

Installation Instructions
2
DISCLAIMER
Milestone AV Technologies, and its affiliated corporations and
subsidiaries (collectively, "Milestone"), intend to make this
manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Milestone
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes
no responsibility for accuracy, completeness or sufficiency of
the information contained in this document.
Chief® is a registered trademark of Milestone AV Technologies.
All rights reserved.
IMPORTANT SAFETY INSTRUCTIONS
WARNING
alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION
alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
WARNING
:
FAILURE TO READ AND
FOLLOW THE FOLLOWING INSTRUCTIONS CAN RESULT
IN SERIOUS PERSONAL INJURY, DAMAGE TO EQUIPMENT
OR VOIDING OF FACTORY WARRANTY. It is the installer’s
responsibility to make sure all components are properly
assembled and installed using the instructions provided.
IMPORTANT ! : Installation and maintenance of this
product must be completed by a qualified service
technician.
When using an electrical mounting system, basic precautions
should always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING THIS
PRODUCT!!!!
DANGER:
TO REDUCE THE RISK OF
ELECTRIC SHOCK:
1. Always unplug this mounting system from the electrical
outlet before cleaning.
WARNING:
TO REDUCE THE RISK OF
BURNS, FIRE, ELECTRIC SHOCK, OR INJURY TO
PERSONS:
• Unplug from outlet before putting on or taking off parts.
• Use this mounting system only for its intended use as
described in these instructions. Do NOT use
attachments not recommended by the manufacturer.
• Never operate this mounting system if it has a
damaged cord or plug. If it is not working properly,
return the mounting system to a service center for
examination and repair.
• Keep the cord away from heated surfaces.
• Never operate the mounting system with the air
openings blocked. Keep the air openings free of lint,
hair, and the like.
• Never drop or insert any object into any opening.
• Do not use outdoors unless marked for outdoor use.
• Route cords and cables as shown in the installation
instructions.
• To disconnect, turn all controls to the off position, then
remove plug from outlet.
WARNING
:
RISK OF ELECTRIC SHOCK!
Connect this mounting system to a properly grounded outlet
only. See Grounding Instructions.
CAUTION:
Changes or modifications to this
unit not expressly approved by the manufacturer can void the
units FCC compliance rating and make the unit illegal to
operate.
WARNING
:
Failure to provide adequate
structural strength for this component can result in serious
personal injury or damage to equipment! It is the installer’s
responsibility to make sure the structure to which this
component is attached can support five times the combined
weight of all equipment. Reinforce the structure as required
before installing the component. The wall to which the mount is
being attached may have a maximum drywall thickness of 1/2"
(12.7mm).
NOTE: The CM8 weighs 21.5 lbs (9.8 kg).
WARNING
:
Exceeding the weight capacity
can result in serious personal injury or damage to equipment! It
is the installer’s responsibility to make sure the combined
weight of all components attached to the CM8 does not exceed
150 lbs (68 kg), with a maximum display size of 61 in.
(154.9cm). Use with products heavier than the maximum weight
indicated may result in collapse of the mount and its
accessories causing possible injury.
NOTE: This system has no user serviceable parts.
--SAVE THESE INSTRUCTIONS--