Dell PowerEdge 860 - Manual (Page 5)

Getting Started With Your System
3
System Features
The major hardware and software features of your system include:
• 1U/1S rack-mountable chassis with support for static rails and sliding rails.
NOTE:
Use the System Setup program to view processor information. See "Using the System Setup
Program" in your Hardware Owner’s Manual.
• One of the following processors:
– One Intel
®
Core™ 2 Duo
– One Intel Celeron
®
D, 300 Sequence
– One Intel Pentium
®
4, 600 Sequence
• A minimum of 512 MB of 533-MHz or 667-MHz DDR2 SDRAM memory, upgradable to a
maximum of 8 GB by installing combinations of 512-MB, 1-GB, or 2-GB unbuffered ECC
memory modules in four memory module sockets on the system board.
• One of the following riser card options:
– One full-height, half-length, x8 lane PCIe expansion slot and one full-height, half-length
PCIe expansion slot with a x8 connector but with a x4 lane capability.
– One full-height, half-length, 133MHz/64 bit PCI-X expansion slot and one full-height, half-
length, x8 lane PCIe expansion slot, which includes a connector for an optional remote access
controller (RAC) card.
• One 3.5-inch CD, DVD, or combination CD-RW/DVD in a peripheral drive bay.
• Support for the following internal hard-drive configurations:
– Up to two internal, 1-inch high, SATA hard drives with the integrated drive controllers.
– Up to two internal, 1-inch high optional Serial-Attached SCSI (SAS) hard drives with an
optional SAS controller card.
• Optional remote access controller for remote systems management. This option requires a riser
card with support for PCI-X and PCIe RAC connectors.
• Optional USB flash drive emulates a diskette drive or hard drive.
• One 345-W power supply.
• Two integrated Gigabit Ethernet network adapters, capable of supporting 10-Mbps, 100-Mbps,
and 1000-Mbps data rates.