Dell PowerEdge 2800 - Manual (Page 8)

6
Information Update
www
.dell.com | support.dell.com
NOTE:
To avoid false error messages, use only the Intel
®
NIC drivers provided by Dell.
Changing the LCD Display of the System ID and Name
To change the LCD display of the system ID and name, enter the System Setup program as
described in the
User’s Guide and select Embedded Server Management from the main setup
screen. Then, in the screen that opens, select User-Defined, and under User Defined LCD String:
enter the desired system ID for Line 1 and system name for Line 2.
LCD Status Messages Update
Table 1-2 lists updates to the LCD status messages that can occur, and the probable cause
for each message. The LCD messages refer to events recorded in the system event log (SEL).
For information on the SEL and configuring system management settings, see the systems
management software documentation.
NIC1 BMC access disabled
after team is created Normal teaming functionality Normal teaming functionality
Table 1-2. LCD Status Messages
Line 1
Message Line 2
Message Causes Corrective Actions
SYSTEM
ID
SYSTEM NAME SYSTEM ID is a unique name,
five characters or less, defined
by the user.
SYSTEM NAME is a unique
name, 16 characters or less,
defined by the user.
The system ID and name display
under the following conditions:
• The system is powered on.
• The power is off and active
POST errors are displayed.
This message is for information
only.
You can change the system ID
and name in the System Setup
program. See your User's Guide
for instructions.
Table 1-1. Effect of BMC Use of NIC1 on Teaming Functionality (continued)
AFT, ALB/RLB, and SFT
Teaming Mode IEEE 802.3ad and Ether Channel
Teaming Mode
Action Effect Effect