Installing the system in the rack, Figure 1-6, Installing the versarails slide assemblies – Dell PowerEdge 2850 User Manual
Page 16
1-14
Rack Installation Guide
Figure 1-6.
Installing the VersaRails Slide Assemblies
Installing the System in the Rack
CAUTION:
If you are installing more than one system, install the first system in the lowest available
position in the rack.
CAUTION:
Never pull more than one component out of the rack at a time.
1
Pull the two slide assemblies out of the rack until they lock in the fully extended position.
CAUTION:
Because of the size and weight of the system, never attempt to install the system in the slide
assemblies by yourself.
2
Lift the system into position in front of the extended slides (see Figure 1-7).
3
Place one hand on the front-bottom of the system and the other hand on the back-bottom
of the system.
front of rack
slide assembly (2)
10-32 x 0.5-inch flange-
head Phillips screw
(4 per slide assembly)
mounting-bracket flange