Dell LCD TV W2306C - Manual (Page 32)

32 Troubleshooting Your LCD TV Display
www
.de
ll
.co
m |
sup
por
t.d
e
ll
.c
om
Poor picture quality when using a
device connected to the ANT/Cable
(coaxial) connector
1 Ensure LCD TV display is selected as the input source in the
Input Select menu. See "Input Select Menu" on page 24 for
more information.
2 Press Menu on the remote control, select Setup, and then select
Channel Setup. This resets the channels on your remote.
3 Check the aspect ratio settings in the TV Menu. Press the Menu
button on the remote control and select Size. For more
information on using the TV Menu, see "Using the TV Menu"
on page 23.
4 Reset the original factory defaults. Press Menu on the remote
control, select Setup, and then select Factory Reset.
5 Adjust the color temperature. Press Menu on the remote
control, select Picture, and then select Color Temperature.
6 The problem may be with your device, contact your service
provider.
Nothing appears on my LCD TV
display
1 Ensure the LCD TV display is turned on.
2 Verify that all the cables are properly connected to the LCD TV
display, including the power cable.
3 Check to see if there is a blue or amber light on the lower,
right-hand corner of the LCD TV display. A blue light indicates
the LCD TV display is on. An amber light means the LCD TV
display is in power save mode.
4 Ensure the proper source is selected in the Input Select menu.
See "Input Select Menu" on page 24 for more information.
5 Reconnect any devices that are currently connected to the LCD
TV display. If you are using multiple devices, connect and test
one device at a time.
6 Connect another device that you know is working properly.
7 Reset the original factory defaults. Press Menu on the remote
control, select Setup, and then select Factory Reset.
Problem Possible Solution