Citizen Systems 291 - Manual (Page 42)

CBM-290/291 User’s Manual
28 CITIZEN
•
When the values set in m (bit image mode) are out of the above range, the data following after n1 is
processed as normal printing data.
•
After completion of bit image printing, printer returns to normal data processing mode.
(9) Specifying/ Canceling Underline (ESC - n)
Code: [1B]h + [2D]h + n
* {0
≤
n
≤
02} data is described in Hex code.
Specifying/canceling an underline.
•
An underline is attached to the full character width. It is, however, not attached to the part
•
having been skipped by horizontal tab command.
•
An underline is not attached to a 90 ° - right-turned characters.
•
Types of underlines by n value are shown below:
n (Hex) Type
0 Canceling an underline.
1 Specifying an underline for 1-dot width.
2 Specifying an underline for 2-dot width.
(10) Specifying 1/6 inch line feed rate (ESC 2)
Code : [1B]h + [32]h
The line feed rate per line is specified by 1/6 inch.
(11) Setting line feed rate of minimum pitch (ESC 3 n)
Code : [1B]h + [33]h + n
* {0
≤
n
≤
FF} data is described in Hex code.
The line feed rate per line is specified by n/360 inch.
•
The initial value is n = 60(1/6 inch)(18H), being 4.23 mm line feed rate.