Citizen Systems 291 - Manual (Page 54)

CBM-290/291 User’s Manual
40 CITIZEN
(40) Aligning the characters (ESC a n)
Code : [1b}h + [61]h + n
* {0
≤
n
≤
2} Data is described in Hex code.
All the printed data within one line are aligned in the specified position.
•
Depending on n value, positional alignment is carried out as in the table below:
n (Hex) POSITION
0 Left end alignment
1 Centering
2 Right end alignment
•
This is valid only when n is inputted at the beginning of line.
•
The initial value of n is "0".
(41) Full Cut (ESC i)
Code : [1B]h + [69]h
Activating auto cutter (Full cut)
•
This is valid only when n is inputted at the beginning of line.
•
Make sure to feed the paper by 18 mm or more before cutting paper, unless characters remain before
the cutting point.
Print Result Cutting Condition