Casablanca Fan Company CASABLANCA Wilderness CEILING FAN 86UxxM - Manual (Page 7)

7
W
ilderness
™
Step 10. To reach the blade holder mounting holes in the fan
motor the switch housing cap must be removed. Take out the
two 8-32 X 3 /
8
” screws securing the switch housing cap and
remove. Put the two (2) screws aside for the moment, they
will be used in Step 15 to install the switch housing cap after
the blades are installed.
SwITCH HOUSINg CAP
mOUNT SCREw
8-32 X 3 /
8
”
(2)
SwITCH
HOUSINg
CAP
note: Save these two screws–they
will be used in Step 15!
BLADE SCREw
AND wASHER
(4 PER BLADE)
BLADE
HOLDER
BLADE HOLDER
SCREw
(2 PER BLADE)
Step 11. Attach each blade to a blade holder by first press-
ing the blade badge into the blade, then installing the blade
holder using the four blade screws provided for each blade.
Using a screwdriver tighten securely by hand only.
Repeat for each blade assembly
BLADE SCREw
AND wASHERS
(4 PER BLADE)
BLADE
BLADE
HOLDER
BLADE
REMOVE DUMMY SWITCH HOUSING & SHIPPING BLOCK
BLADE & BLADE HOLDER HARDWARE
BLADE BADGE INSTALLATION