Canon DR-7090C - Manual (Page 24)

16
1.
Turning the Power ON
This section describes how to turn ON the scanner.
About the Power Switch
The power switch is located on the scanner’s side panel, and
the following appears on the display panel when the power
switch is turned ON. (See p. 54.)
IMPORTANT
• When connecting the scanner to the computer using a SCSI
cable, be sure to turn ON the scanner first, and then turn ON the
computer. If you turn ON the computer first, the scanner may not
be properly recognized by the computer.
• Press the power switch again to turn the scanner OFF.
• After turning the scanner OFF, wait at least 10 seconds before
turning it ON again.
• If you will not be using the scanner for an extended period,
disconnect the power cord from the AC outlet for safety.
Power Switch
Display panel