Classe Audio Surround Sound Processor SSP-800 - Manual (Page 27)

27
Step 6 Power up the system!
Now you are ready to power up your SSP-800 and your surround system.
• Turn the rear panel power switch of the SSP-800 to ON.
• Th
e initial power-up cycle of the SSP-800 takes approximately 90
seconds. During this time, the blue LED on the standby button fl ashes.
• When the power-up cycle is complete, the SSP-800 enters Standby
mode. Th e LED stops fl ashing but remains illuminated, indicating
that the SSP-800 is in Standby mode. Refer to the Front Panel
section, for more details about Standby mode.
• Press the Standby button or the front panel touchscreen to bring the
SSP-800 to its fully ON mode. Th e front panel touch screen displays
a blue screen with an “initializing” message and then switches to the
home page of the menu system. Refer to the Menu System section
found later in the manual for more information.
Th e physical setup of the SSP-800 and system components is complete.