Dell XPS/Dimension XPS Gen 4 User Manual
Page 27
See the documentation that came with the card for information on configuring the card, making internal connections, or otherwise customizing it for your
computer.
6.
If you are installing the card into the x16 card connector, position the card so the securing slot is aligned with the securing tab, and gently pull the
securing tab.
7.
Place the card in the connector and press down firmly. Ensure that the card is fully seated in the slot.
If the card is full-length, insert the end of the card into the card guide bracket as you lower the card toward its connector on the system board. Insert
the card firmly into the card connector on the system board.
8.
If you replaced a card that was already installed in the computer and you removed the top of the retention mechanism, you may reinstall the top.
9.
Before you lower the retention arm, ensure that:
l
The tops of all cards and filler brackets are flush with the alignment bar.
l
The notch in the top of the card or filler bracket fits around the alignment guide.
10.
Press the retention arm into place, securing the card(s) in the computer.
11.
Connect any cables that should be attached to the card.
See the documentation for the card for information about the card's cable connections.
12.
Close the computer cover, reconnect the computer and devices to electrical outlets, and then turn them on.
13.
If you installed an add-in network adapter and want to disable the integrated network adapter:
a.
Enter the system setup program
, select Network Controller, and then change the setting to Off.
CAUTION:
Some network adapters automatically start the computer when they are connected to a network. To guard against electrical shock, be
sure to unplug your computer from its electrical outlet before installing any cards.
NOTICE:
Do not route card cables over or behind the cards. Cables routed over the cards can prevent the computer cover from closing properly or
cause damage to the equipment.
NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.