Citizen Systems CBM-290 - Manual (Page 37)

CITIZEN 37
(15) Specifying/canceling Double Printing (ESC G n)
Code : [1B]h + [47]h + n
* {0
≤
n
≤
FF} Data is described in Hex code.
Specifying/canceling the double printing.
l "n" is valid only for the lowest bit (n0).
l Control by n is shown as follows.
n0 Type
0 Canceling double printing.
1 Specifying double printing.
l The print result of Double printing and highlight character printing is completely same
.
(16) Printing and feeding paper at minimum pitch (ESC J n)
Code : [1B]h + [4A]h + n
* {0
≤
n
≤
FF} Data is described in Hex code.
Prints data inside the print buffer and feeds paper by n/360 inch.
l Specified volume does not remain.
l The beginning of the line is to be considered as the next printing start position.
l Initial value is not defined.
(17) Selecting International Characters (ESC R n)
Code : [1B]h + [52]h + n
* {0
≤
n
≤
0A) Data is described in Hex code.
Selecting international characters.
l Depending on the value of n, following character sets are specified.
n(Hex) CHARACTER SET
0 U.S.A.
1 France
2 Germany
3 U.K.
4 Denmark 1
5 Sweden
6 Italy
7 Spain
8 Japan
9 Norway
10 Denmark 2
l The initial value of n indicates the character set specified by Jumper setting (J1 - J3).
(18) NOP (ESC c3)
(19) NOP (ESC c5)