Char-Broil 463741008 - Manual (Page 17)

463741008 • 17
8
(A) P
osition heat shield as shown. Attach with
#10-24x1-1/4" carriage bolt, fiber washers and #10-24
wing nut.
(B) Place burner assembly into firebox. Make sure venturi tubes and valves are correctly engaged. Place small end of venturi clip
into venturi tube and large part of clip around valve. If burner is not leveled from left to right, adjust the two screws attaching valve
to control panel in step 8B. Place control knobs on valves as shown in figure (A).
(C) Inside firebox, attach firebox and control panel with fiber washers and #8 sheet metal screws.
(D) Attach ignitor wire to electrode.
lace firebox onto cart. P
Shelf
Qty: 8
#10-24x1-3/4"
Machine Screw
Correctly assembled burner tube and venturi clips valve in
B
Venturi Clip
Venturi Tube
Qty: 4
#10-24x1-1/4"
Carriage Bolt
Qty: 4
#10-24
Wing Nut
Qty: 6
Fiber Washer
Qty: 2
#8 Sheet Metal
Screw
9 Attach side shelves with
#10-24x1-3/4" machine screws.
C
Valve
Left Side
Right Side
B
Burner Assembly
D Ignitor Wire Heat shield
Firebox
Control knobs
A
C