Canon CR-80 - Manual (Page 11)

11
Preparation Before Use
This chapter describes how to prepare the scanner to scan
documents.
Setting Up the Scanner
Perform the following steps to set up the CR-50/80. Refer to the
section for each step for details about that step.
1
Check your operating environment. (See “Checking Your
Operating Environment” on p. 12.)
2
Install the software. (See “Installing the Scanning Utility”
on p. 12.)
Install the Scanning Utility provided with the CR-50/80.
3
Connect the scanner to a computer. (See “Connecting the
Scanner to a Computer” on p. 13.)
4
Turn ON the power. (See “Turning ON the Power” on
p. 14.)
5
Automatically installing the device driver. (See p. 15.)
The device driver is installed automatically when Windows
recognizes the CR-50/80.
IMPORTANT
• To have the device drivers installed automatically when the
computer recognizes the CR-50/80, the software needs to be
installed before the CR-50/80 is connected to the computer.
• If you connect the computer and turn ON the CR-50/80 before
installing the software, the following wizard screen appears. If this
happens, click [Cancel], turn OFF the CR-50/80, and then install the
software.
The following wizard screen is an example in Windows 7. When a
similar wizard screen appears in Windows XP/Vista, click [Cancel].
Wizard Screen (Windows 7)