Casio AX200 - Manual (Page 61)

www.axxessid.com
Installation & User Guide
AX200 Installation & User Guide – July 2007 6 1
Firmware Version
Firmware revision number in AX100 PCB
Batch Number
Production identity number
Serial Number in Batch
Serial number to be used with batch number
Database Stamp
This number is automatically generated and ensures the correct data is automatically
downloaded. If another PC is connected, this number is different and a forced download is
required since the data held on the PC and the AX100 controller are different.
Access Groups
Access groups give you the possibility to gain access through more than one door by using a
single card. Once the access group is assigned to a card (in the card holder section) you can
open all the doors listed in the access group.
The menu on the right hand side of the screen contains all the access groups created in the
software. All & None are the defaults. The first group in the list is automatically highlighted when
you open the Access groups tab.
Access group tab contains two separate lists: Controller(s) available & Selected Controller(s)
in Group. The first list contains all the access points that have not yet been assigned to the
highlighted access group. Therefore if group “All” was highlighted the “Controller(s) available” list
would be blank. The access group ‘All’ gives access automatically to all AX200 controllers
including new ones added at a later date and cannot be deleted or altered.
The Fixed sign in the Group Configuration section means you cannot change any information
displayed on the screen.