Cobra Electronics COBRA XRS 930 - Manual (Page 4)

Nothing Comes Close to a Cobra ®
Installation
Your Detector
3
Installation
Your Detector
English 2
Installation
•
Where to Mount Your Unit
You will get optimum performance from your detector if you Mount it at a point
approximately in the center of the vehicle, as low as possible on the front
windshield without obstructing the unit’s view of the road either to
the front or rear. Make sure unit is level with the road. You can also mount
it directly on the dashboard.
The unit’s lens must not be blocked and the LaserEye should have a clear view out
the back window to allow 360° detection.
Radar and laser signals pass through glass but not through other materials and
objects. Objects that can block or weaken incoming signals include:
■
Windshield wiper blades
■
Mirrored sun screens
■
Dark tinting at the top of the windshield
■
Heated windshields currently available on some vehicles
(Instaclear for Ford, Electriclear for GM.) Consult your dealer
to see if you have this option.
1. Attach the rubber
cups to the bracket.
2. Make sure the rubber cups and your windshield are clean.
3. Push the bracket firmly onto
the windshield.
4. Attach the detector to
the bracket. Check the
angle of the unit.
5. To adjust the angle if
necessary, gently push or pull
on the bracket to bend it. DO
NOT use the detector to bend
the bracket.
6. Plug the power cord
into the detector.
7. Plug the cigarette lighter
adapter on the power
cord into your vehicle’s
cigarette lighter.
8. You can temporarily remove the detector whenever you
wish by pressing the bracket release button and sliding
it off the bracket.
Windshield Mounting
The LaserEye Should Have a Clear View
Windshield Mounting Dashboard Mounting
XRS930_MANL:9492-XRS9330 12/18/09 8:28 AM Page 2