Canon C50 - Manual (Page 41)

Canon MultiPASS C50 Getting Started ENGLISH
II-24
Message Error Code Cause Action
MEMORY FULL #037 The MultiPASS C50’s
memory is full because
it has received too
many documents, or a
very long or detailed
document.
Print out any documents
that are stored in memory.
Then start the operation
again. See page 5-12.
The memory is full
because you sent too
many pages at once, or
a very long or detailed
document.
Divide the document and
send each part separately.
If the memory contains any
faxes, you do not need to
delete them.
MEMORY FULL
PLEASE WAIT
– The MultiPASS C50 is
sending a fax and its
memory is full.
Wait until the fax is sent.
The MultiPASS C50
continues to send the fax
as memory becomes
available.
MEMORY USED nn% – Shows how much of the
MultiPASS C50’s
memory is in use.
If you need more memory,
print or send any
documents stored in
memory.
NO ANSWER #005 The receiving fax
machine does not
answer.
Make sure you dialled the
correct number. Try again
later.
NO TEL # #022 The one-touch or
coded speed dialling
number has not been
registered.
Register the number.
NOT AVAILABLE – In manual sending via
the handset, you tried
to use a one-touch
speed dialling button or
a coded speed dialling
code that has a group
registered in it.
In manual sending via the
handset, you cannot send a
document to multiple
destinations. Send the
document to one
destination at a time.
PLEASE WAIT – The MultiPASS C50 is
warming up.
Wait until the time and
receiving mode appear in
the LCD display, then
begin.
PUT IN CARTRIDGE – The BJ cartridge is not
installed properly.
Make sure the BJ cartridge
is installed properly and
the green lock lever is set
properly.