Vermont Casting 4065 - Manual (Page 25)

25
Pinnacle & Stardance Direct Vent - Rear Vent Gas Heaters
20007066
Install the Log Set
Remove the logs from their packaging, and inspect
each piece for damage. DO NOT INSTALL DAMAGED
LOGS.
1. Install the rear log by centering it side to side on the
sheet metal shelf at the back of the firebox. (Fig. 43)
The log will touch both sides and back wall of the
firebox.
2. Install the right log by placing right side of log on
burner so it is just touching firebox side. Lay log flat
on burner almost touching the decorative grate.
Then tilt log back so that it leans against rear log.
(Fig. 43) Only the topmost part of the left side of log
will touch the rear log. The right log sits freely on the
burner and does not use locator pins to stay in
place.
3. Place left log on burner, making sure to engage
locator pins in holes in bottom of the log. (Fig. 43)
This log does not touch any other log.
4. Sprinkle lava rock on burner in front of, and
between, left and right logs. (Fig. 44)
Right Log
Rear Log
Left Log Decorative Grate LG138
Fig. 43 Install back, right and left logs.
Decorative Grate
Lava Rock
LG139
Fig. 44 Place lava rock on burner.