Canon D I G I T A L C A M E R A CDI-E019-010 - Manual (Page 99)

95
Macintosh
What to Do if the “ImageBrowser not found” Dialog Appears
If you install only the Canon Digital Camera Plug-In Module without ImageBrowser,
the “ImageBrowser not found” dialog may display. If this happens, use the following
procedures to prevent ImageBrowser from attempting to start automatically.
1. Click the [OK] button on the “ImageBrowser not found” dialog.
2. In the “Settings for USB connection” dialog, click the [The application program
below will start.] option to clear the check mark.
3. Close the “Settings for USB
connection” dialog.
This will prevent the
“ImageBrowser not found” dialog
from appearing again when the
camera is connected.
• The “Settings for USB
connection” dialog can be
opened by choosing the Apple
menu and selecting
[Control Panels] and [Canon
USB Camera]. (➜ p. 66)
Connecting via a CF Card Reader or PC Card Slot
1. Place the CF card into the CF card reader or into the PC card adapter
and then into the PC card slot.
Refer to Where to Find Instructions for Attaching Your Camera to a
Computer (➜ p. ii) for connection instructions.
2. Start Adobe PhotoDeluxe.
Serial Interface
About AppleTalk
When connected to the printer or modem port via AppleTalk, choose the Apple
menu , select [Chooser] and set AppleTalk to [Inactive].
1. Connect the camera to the computer with the serial cable.
Refer to Where to Find Instructions for Attaching Your Camera to a
Computer (➜ p. ii) for connection instructions.
2. Set the camera to the mode for communicating with a computer.
3. Start Adobe PhotoDeluxe.
Click here to
clear the
check mark.
Click here
to close the
dialog.