Nikon S3100 - Manual (Page 80)

68
Shooting Smiling Faces (Smart Portrait Mode)
More on
Sh
ooting
Changing Smart Portrait Mode Settings
While using F (smart portrait) mode ( A 66), press the d button (A 10) and
then set the following options in the smart portrait menu.
Use the multi selector to choose and apply settings ( A 9).
Press the
d button to exit the menu.
Image mode
Choose the image mode (combination of image size and compression rate) at
which images are saved (
A 38).
Changes made to the image mode setting are applied to all shooting modes.
Skin softening
Enable skin softening. When the shutter is released, the camera detects one or more
human faces (up to three), and processes the image to soften facial skin tones
before saving the picture.
The degree of skin softening applied can be selected from
High, Normal (default
setting), and
Low. When Off is selected, the skin softening function is disabled.
• The current setting can be confirmed by the indicator displayed in the monitor
with shooting ( A 6). No indicator is displayed when Off is selected. The effects
of skin softening are not visible when framing pictures for shooting. Check the
degree of skin softening performed in playback mode.
Smile timer
• On (default setting): The camera uses face detection to detect a human face, and
then automatically releases the shutter whenever a smile is detected.
• Off: The camera does not release the shutter automatically with smile detection.
Press the shutter-release button to take a picture.
• When smile timer is enabled, an indicator is displayed in the monitor with
shooting ( A 6). No indicator is displayed when Off is selected
Blink proof
When
On is selected, the camera automatically releases the shutter twice each time
a picture is taken. Of the two shots, one in which the subject’s eyes are open is
saved.
• If the camera saved a picture in which the subject’s
eyes may have been closed, the dialog shown at
right is displayed for a few seconds.
• Flash cannot be used when On is selected.
• The default setting is Off.
• The current setting is displayed in the monitor
( A 6). No indicator is displayed when Off is
selected.
A blink was detected in the
picture just taken.