Dell Precision R7610 (Mid 2013) - Manual (Page 120)

Power Management
AC Recovery Determines how the system responds when AC power is re-applied after a power loss.
You can set the AC Recovery to:
• Power Off (default)
• Power On
• Last State
Auto On Time Sets time to automatically turn on the computer. Time is kept in standard 12-hour
format (hour:minutes:seconds). Change the startup time by typing the values in the time
and AM/PM fields. The options available are:
• Disable (default)
• Every Day
• Weekdays
NOTE: This feature does not work if you turn off your computer using the switch on
a power strip or surge protector or if Auto Power is set to disabled.
Deep Sleep Mode Determines how aggressive the computer is at conserving power while it is shutdown
or in Hibernate mode.
Enable Low Power Mode — Disabled by default
Remote Wake Up Determines if the system can be powered up remotely from Suspend, Hibernate, or Off.
• Disable
• Enable
• Enable with Boot to NIC
Maintenance
Service Tag Displays the Service Tag of your computer.
Asset Tag Allows you to create a system asset tag if an asset tag is not already set.
System Management Controls the System Management mechanism.
• Disable (default)
• DASH/ASF 2.0
SERR Messages Controls the SERR message mechanism.
Enable SERR Messages — Enabled by default
POST Behavior
Fast Boot Allows speeding up the boot process by bypassing some compatibility steps.
Enable Fast Boot — Enabled by default
Numlock LED Specifies if Numlock feature should be on when your computer starts.
Enable Numlock LED — Enabled by default
POST Hotkeys Specifies if the sign-on screen displays a message stating the keystroke sequence
required to enter the Setup program or the QuickBoot feature.
Enable F12 = Boot menu — Enabled by default
120