Dell OptiPlex E1 - Manual (Page 82)

the driver resides. The default is c:\plugplay.
At least one
Plug
and Play card
in
your system is
not
configured due
to
conflicts. These
are marked
"config
err" in the list of
configured
cards.
Due to conflicts,
the ICU could
only
configure some
Plug
and Play cards
in
your system.
Un-
configured
cards
are marked
"config
err" in the list of
configured
cards.
The Configuration
Manager or the ICU cannot
configure at least one
Plug and Play expansion
card because of resource
conflicts with one or
more cards.
You must reconfigure the conflicting card(s). To find the conflicting card,
perform the following steps:
1. Select the Plug and Play expansion card marked with config err,
and then click the Modify button.
The Card Configuration dialog box displays the functions assigned to
the Plug and Play expansion card.
2. Select a function and then click Settings. Click Cancel if the ICU
does not display a message naming the conflicting card.
3. Repeat step 2 until the ICU displays a message box naming the
conflicting card and the resource(s) in conflict. See the following
table entry for an explanation of this message box.
This device is
unconfigurable
because of a
resource
conflict
with card
card_name.
The
conflicting
resource
is
resource_name.
To fix,
reconfigure
the conflicting
card.
The selected card is un-
configurable because one
of its resources is already
being used by another
device.
Perform the following procedure:
1. Make a note of the card name and the type of conflicting
resource.
2. Follow the procedure in " Modifying a Card " and change the
value for resource_name used by card_name.