Dell M109S Projector - Manual (Page 11)

Using Your Projector
11
Using Your Projector
Turning Your Projector On
NOTE:
Turn on the projector before you turn on the source. The Power button light
blinks blue until pressed.
1 Connect the multi-input cable into the projector.
2 Connect the multi-input cable with the power cord and appropriate signal cables. For
information about connecting the projector, see "Connecting Your Projector" on
page 7.
3 Press the Power button (see "Using the Control Panel" on page 14 to locate the Power
button).
4 Turn on your source (computer, DVD player, etc.). The projector automatically
detects your source.
5 The Dell Logo will continue for 10 seconds while power on.
If the "Searching for signal..." message appears on the screen, ensure that the
appropriate cables are securely connected.
If you have multiple sources connected to the projector, press the Source button on
the control panel to select the desired source.
Turning Your Projector Off
NOTICE:
Unplug the projector after properly shutting down as explained in the
following procedure.
1 Press the Power button.
2 Press the Power button again. The cooling fans continue to operate for 10 seconds.
3 Disconnect the AC adapter from the multi-input cable.
4 Disconnect the multi-input cable from the projector.
NOTE:
If you press the Power button while the projector is running, the "Press
Power Button to Turn off Projector" message appears on the screen. To clear the
message, press the Menu button on the control panel or ignore the message; the
message disappears after 30 seconds.