Dell PowerVault DR4100 - Manual (Page 28)

28 DR4100 Best Practice Guide | April 2014
1. Set bond0 to 1GB using the following command:
network --factory_reset [--auto_bonding_speed <1G|10G>]
2. Use the following command to view the new configuration:
network --show
3. Create a bond for the 2x 10GB interfaces using the following command:
Example
administrator@DR1 > network -- factory_reset –auto_bonding_speed 1G
Warning: This will stop all system operation and will reset the network configuration to
factory settings and will require a system robbon. Existing configuration will be lost.
One or more of these interfaces 'eth0,eth1' are in use by an application.
Factory reset cannot be done while interfaces are in use by an application.
Factory reset will remove all application interface settings.
Password required to proceed. Please enter the administrator password :
administrator@DR1 > System --reboot
Example
administrator@DR1 > network -- show
Automatic bonding speed: 1G
Device : bond0
Enabled : yes
Link : yes
Boot protocol : dhcp
IP Addr : 10.250.242.173
Netmask : 255.255.252.0
Gateway : 10.250.240.1
MAC Addr : BC:30:5B:F3:22:74
MTU : 9000
Bonding options : "mode=balance-alb miimon=100 xmit_hash_policy=2"
Member Interfaces : eth0,eth1
eth0 MAC
: BC:30:5B:F3:22:74
eth0 Max Speed :1000baseT/Full
eth0 Speed :1000Mb/s
eth0 Duplex :Full
eth1 MAC : BC:30:5B:F3:22:75
eth1 Max Speed :1000baseT/Full
eth1 Speed :1000Mb/s
eth1 Duplex :Full