Removing the optical drive – Dell PowerEdge R200 User Manual
Page 2
Removing and Installing the Optional SATA
Optical Disk Drive
The following section updates the optical disk drive removal and installation
procedures in your system documentation.
Removing the Optical Drive
CAUTION:
Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
1 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet and peripherals.
2 Open the system. See "Opening the System" in your Hardware Owner’s
Manual.
3 Disconnect the SATA power and data cables from the optical drive.
See Figure 1.
4 Press the bracket release lever that secures the optical drive to the hard
drive 0 carrier.
5 Lift and tilt the optical drive up and out of the bracket.
KY107ap3.fm Page 2 Thursday, June 19, 2008 5:05 PM