Dell Dimension 4600 - Manual (Page 12)

Installing an AGP Card
1. To add or replace the card, press the card lever toward the PCI connector and gently press the card into the AGP connector until it clicks into place.
2. Release the card lever, ensuring that the tab fits into the notch on the front end of the card.
3. Secure the card with the securing screw.
4. If your computer did not previously have an AGP card installed, move the monitor cable to the VGA connector on the new card.
5. Replace the computer cover .
6. Connect your computer and devices to electrical outlets, and turn them on.
Memory
You can increase your computer memory by installing memory modules on the system board. For information on the type of memory supported by your
computer, see "
Memory ."
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
NOTE: DDR 333 memory operates at 320 MHz when used with an 800-MHz front-side bus.