Dell PowerVault MD3800f - Manual (Page 21)

Rescan And Enable The SRAs
Once the storage arrays on both the protected and recovery sites have been discovered:
1. From the Array Managers view, click the SRAs tab.
The SRAs tab should look similar to this:
Figure 15. Array Managers View
2. Select the protected site and click Rescan SRAs.
3. Select the recovery site and click Rescan SRAs.
4. Select either the Protected or Recovery spindle in the Array Managers view.
5. Select the Array Pairs tab.
6. Click Enable to activate the SRA on both the protected and recovery sites.
The SRAs should be loaded into SRM. Check the Summary tab to ensure that they display properly.
21