Dell PowerVault 745N - Manual (Page 78)

Multilingual Support CD.
1. Insert the Multilingual Support CD into the NAS system's CD drive.
2. On the client system, in the Sharing tab on the Compact Disk Properties page, click the radio button next to Share this folder to share the CD drive
3. From a client system, log in to the NAS Manager.
4. Click Maintenance, and then click Remote Desktop.
5. Log in to the system as an administrator.
6. Map a network drive to the CD share by right-clicking My Network Places and selecting Map Network Drive.
7. Browse to the mapped drive and double-click MUISETUP.exe to launch the Multilingual User Interface installer program
8. In the installer window, select the languages to be installed, and select the default MUI language from the menu.
9. Click OK to perform the installation.
10. After the installation is complete, reboot your system.
Applying the MUI Language
After a MUI language has been installed, you can apply it to any user by performing the following steps:
1. From a client system, log in to the NAS Manager.
2. Click Maintenance.
3. Click Remote Desktop.
4. Log in to the system as an administrator.
5. Click the Start button and select Settings→ Control Panel.
6. In the Control Panel, double-click Regional and Language Options.
7. On the Regional Options tab, select the appropriate region under Standards and Formats.
8. Click the Languages tab and select the appropriate language used in menus and dialogs.
9. Log off and log in to the system again for the new language MUI to take effect.
Network Adapter Teaming
Network adapter teaming allows the system to use the combined throughput of multiple network ports in parallel to increase performance or to provide fault
tolerance. Network adapter teaming on your NAS system supports the following modes:
l Adaptive Load Balancing (ALB)
l Receive Load Balance (RLB)
l Switch Fault Tolerance (SFT)
l Adapter Fault Tolerance (AFT)
l Intel Link Aggregation
l Fast EtherChannel (FEC) and Gig EtherChannel (GEC)
l IEEE 802.3ad Static
l IEEE 802.3ad Dynamic
NOTE: Installing and configuring the operating system MUI does not affect the language used by the NAS Manager.
NOTE: The default administrator user name is administrator and the default password is powervault.
NOTE: The default administrator user name is administrator and the default password is powervault.
NOTE: When creating or removing network adapter teams, the IP address of the NAS system's LAN connections changes. To prevent disconnection from
the NAS system during team configuration, connect a keyboard, monitor, and mouse to the NAS system when creating or removing teams. See
"
Configuring Your System Using a Keyboard, Monitor, and Mouse " in " Initial Configuration " before configuring your teams.