Dell Inspiron 10z (1120, Mid 2010) User Manual
Page 3
DL?
ATDL?
Display last dialed number
DSn
ATDSn
Dial stored number
E0
ATE0
Turn command echo off
E1
ATE1
Turn command echo on
X
F0
ATF0
Turn online echo on
F1
ATF1
Turn online echo off
X
H0
ATH0
Hang up (go on-hook)
H1
ATH1
Pick up (go off-hook)
I0
ATI0
Display the 4-digit product code
I1
ATI1
Display the checksum
I2
ATI2
Display the RAM test results
I3
ATI3
Display the firmware version
I4
ATI4
Display the current modem settings
I5
ATI5
Display user profiles
I7
ATI7
Display the product configuration
I8
ATI8
Display black list screen
I10
ATI10
Display VXD configuration screen
I11
ATI11
Display V.34 link screen
L0
ATL0
Set modem speaker volume off
L1
ATL1
Set modem speaker volume on (low)
L2
ATL2
Set modem speaker volume on (medium)
X
L3
ATL3
Set modem speaker volume on (high)
M0
ATM0
The modem's speaker is always off
M1
ATM1
The modem's speaker is on until a connection is made
X
M2
ATM2
The modem's speaker is always on
M3
ATM3
The modem's speaker is off during dialing, and on after
dialing until the connection is made
O0
ATO0
Return to online mode
O1
ATO1
Return to online mode and retrain (automatically return to
the highest speed)
S$
ATS$
Display the list of S-register settings
Sr=n
ATSr=n
Set S-Register "r" to "n"
Sr?
ATSr?
Display the value of S-Register "r"
V0
ATV0
Display result codes in numeric form
V1
ATV1
Display result codes in verbose form (words)
X
X0
ATX0
Report basic call progress result codes, i.e., OK,
CONNECT, RING, NO CARRIER, (also, for busy, if
enabled, and dial tone not detected), NO ANSWER and
ERROR
X1
ATX1
Report basic call progress result codes and the connect
rates-OK, CONNECT, RING, NO CARRIER (also, for
busy, if enabled, and dial tone not detected), NO
ANSWER, CONNECT XXXX and ERROR
X2
ATX2
Report basic call progress result codes and the connect
rates i.e., OK, CONNECT, RING, NO CARRIER (also, for
busy, if enabled), NO DIAL TONE, NO ANSWER,
CONNECT XXXX and ERROR
X3
ATX3
Report basic call progress result codes and connection